4 – Channel D Class Amplifier – (125W x 4) High
Pass Filter 12dB.oct Filter Frequency 20Hz-4kHz (front) 20Hz-
4kHz(rear) / Low Pass Filter 12dB.oct Filter Frequency 50Hz-
5kHz(front) 50Hz-5kHz(rear) / RMS Power at 14.4V:
Watts per channel NOT bridged @ 1 kHz 4 ohms 125 watts 2
ohms 200 watts / Watts per channel bridged 4 ohms 400 watts
The PA D4000.4 amplifier is capable of bridging two full-range channels into a single full range channel with higher output power. For instance, one front and one rear channel will increase the output power from 125W per channel to 400W per channel (for a 4 ohm load). The most common hookups for the PA D4000.4 would be four full-range channels, two full-range channels and a bridged sub, or two bridged subwoofers.
Super-efficient class D design�Runs much cooler than conventional amps.
High-speed MOSFET�Switching power supply.
Toroidal transformers�Help keep the amplifier�s sleek design under 2-inch tall while ensuring plenty of clean, efficient power.
Protection�Thermal, DC offset, reverse DC voltage and short circuit protection.
Nickel-plated wire terminals & RCA connectors�Ensure maximum signal transfer.
Front & rear level controls�Adjust the gain of the front and rear channels to match the output voltage from your head unit.
Low-pass & high-pass frequency controls�Enables you to adjust crossover overlap for better blending of speakers.
Front & rear BPF, FULL, HPF switches�Selects full range, high pass filter, or bandpass filter to dial in your speaker blending.
Channel mode switch (ST/4Ch)�In the stereo position, the amplifier will send the same signal to front and rear channels.
Stainless steel hardware�Used throughout won�t corrode in humid environments.